DeWalt DW5468 DeWalt 1-1/8 x 8 x 10 Rock Carbide SDS+ Hammer Bit, 2 Cutter

Using the DeWalt DW5468 is a breeze. First, make sure your hammer drill is compatible with SDS+ bits. Insert the bit firmly into the drill chuck until it clicks into place. When you start drilling, apply gentle and even pressure. Don't push too hard at once, as this can cause the bit to wear out faster or even break. As for maintenance, after each use, wipe the bit clean with a dry cloth to remove any debris. If there's stubborn dirt, you can use a little bit of mild detergent and water, but dry it thoroughly afterward. Store the bit in a dry place to prevent rusting. Also, keep an eye on the bit's tip. If it shows significant wear, it's time to replace it to maintain optimal performance.