Product Description
FEATURES: Safety is paramount with this hoist. It comes with an overload protection via a slip clutch design. This stops the hoist from lifting loads beyond its rated capacity, preventing potential damage. A reverse phase relay safeguards the hoist from wrong power - supply wiring. The DC electro - magnetic brake, a well - known safety feature, holds the load firmly even if power cuts out. Upper and lower limit switches enhance safety by preventing the load chain from over - traveling. For durability, it has a sealed gear train that uses a sealed oil bath, meaning no maintenance is needed. The Grade 80 load chain, coated with black oxide, is built to last. The 24 - volt push - button control pendant has a cable strain relief system, ensuring reliability in industrial and commercial settings. Its all - steel construction, fully enclosed with a durable powder - coat finish, keeps out moisture, dust, and debris, thus extending the hoist's lifespan. SPECIFICATIONS: Headroom is 28 - 1/8 inches. Lift is 10 feet. There are 2 falls. Motor power is 2 - 1/7 HP. Lifting speed is 12 FPM. Duty cycle is 30%. Load chain dimensions are 8 x 24 mm. It has a 3 - phase motor with a voltage of 230 / 460 V. Load capacity is 2 tons, and the duty - cycle rating is H4. JET® SSC Series electric hoists are a great blend of safety and durability for commercial and industrial use. All models have a slip - clutch overload protection. They are available in single or three - phase setups to fit your electrical requirements. Single - phase models prevent overheating, while three - phase models protect against incorrect wiring. The reliable DC electro - magnetic brake and maintenance - free gear train make these hoists a top choice in capacities from ½ ton to 5 tons with standard or custom lifts.
Using this Jet electric chain hoist is straightforward. First, make sure the power supply matches the hoist's specifications (either 230V or 460V, 3 - phase). Connect the hoist properly and check the wiring to avoid any issues with the reverse phase relay. Use the 24 - volt push - button control pendant to operate the hoist. When lifting, don't exceed the 2 - ton load capacity. The limit switches will stop the chain from over - traveling, but it's still good to be cautious. Remember, the hoist has an overload protection feature, so don't try to force it to lift heavier loads. As for maintenance, since it has a sealed gear train, you don't need to do much. Just keep the hoist clean, and the powder - coat finish on the all - steel construction will protect it from moisture, dust, and debris. Regularly check the load chain for any signs of wear. If you notice any problems, stop using the hoist immediately and consult a professional.
