The Milwaukee 2854 - 22 M18 FUEL™ 3/8 inch Compact Impact Wrench with Friction Ring stands out as the most compact in its class. It offers exceptional access in tight spaces, packs a punch with up to 250 ft - lbs of nut - busting torque, and provides maximum visibility in the workspace. Measuring just 4.8 inches in length, this cordless impact wrench is powered by a POWERSTATE™ brushless motor. This motor gives it the muscle to remove stubborn fasteners, even in confined areas. The tri - LEDs surrounding the anvil provide bright, shadow - free lighting, enhancing your work environment. With 4 - Mode DRIVE CONTROL™, you get greater precision. You can choose from a range of pre - set RPM and IPM levels with a single button on the tool. In Mode 4, AUTO SHUT - OFF™ control applies a maximum of 20 ft - lbs of torque for hand - tight fastening, preventing overtightening. It also features Bolt Removal Control, which delivers full torque output and then slows down RPMs once the bolt is loosened to avoid fastener drops. REDLINK PLUS™ Intelligence electronics ensure top - notch performance and protect the tool from overloads, over - heating, and over - discharge. The included M18™ REDLITHIUM™ 5.0Ah battery pack is compatible with all M18™ tools, offering more work per charge and a longer lifespan. This kit comes with one M18 FUEL™ 3/8 inch Compact Impact Wrench with Friction Ring, two M18™ 5.0Ah Batteries, one M12™/M18™ Charger, and a blow - molded case.
Using your Milwaukee 2854 - 22 M18 FUEL™ 3/8 inch Compact Impact Wrench is easy. First, insert the M18™ REDLITHIUM™ 5.0Ah battery into the tool. Make sure it's properly seated. When you're ready to work, select the appropriate mode on the 4 - Mode DRIVE CONTROL™ using the single button on the tool. If you're doing hand - tight fastening, choose Mode 4 to prevent overtightening. When removing bolts, this mode will also slow down the RPMs once the bolt is loosened to avoid dropping the fastener. When using the tool in tight spaces, take advantage of its compact size and the bright tri - LED lighting for better visibility. As for maintenance, keep the tool clean after each use. Wipe it down with a dry cloth to remove any dirt or debris. Don't expose the tool to extreme temperatures or moisture. Store it in the blow - molded case provided when not in use. Also, make sure to charge the battery as needed to keep it in good condition. If you're using the tool in an environment up to 69kV, follow all safety guidelines and procedures.
