Greenlee 0253-03NH-INS Insulated Nut-Holding Nut Drivers, 7 Piece Kit

The Greenlee 0253-03NH-INS kit comes with a 7-piece insulated nut holding driver set and a custom tool roll-up carrier. This set surpasses the IEC 60900 and ASTM F1505 standards for insulated tools. Its non-magnetic design prevents it from attracting metal filings and works well with stainless steel and brass. The dual-layer insulation offers extra safety against electric shocks. The set features a cushion grip handle design. The shank length is 6', and it has a hollow round shank type. The hex sizes include 3/16', 1/4', 5/16', 11/32', 3/8', 7/16', and 1/2'. The blade is made of steel, and it has an insulated shaft with a 1000V voltage rating.

Using the Greenlee nut - holding nut driver kit is easy. First, select the appropriate hex - sized driver from the 7 - piece set according to your nut. Insert the driver into the nut and turn it to tighten or loosen. When using, always make sure the voltage of the environment does not exceed the 1000V voltage rating. The non - magnetic design means it won't attract metal filings, but you should still keep it away from areas with a lot of debris. After use, clean the drivers with a dry cloth to remove any dirt or residue. Store the drivers in the custom tool roll - up carrier to keep them organized and protected. Check the insulation regularly for any signs of damage. If you notice any wear or tear on the insulation, stop using the tool immediately and replace it to ensure your safety.