Product Description
The Jet ProShop Table Saw combines the features of a high - end cabinet saw with the compactness of a contractor - style machine. Its redesigned transparent blade guard has individual leaves, and the quick - release riving knife significantly lowers the risk of kickback. A low - profile riving knife and dado insert are provided for non - through and dado cuts. The exclusive ProShop fence system comes in 30' or 52' rip capacities.
Key features include a newly designed arbor lock for easy blade changes, a hassle - free quick - release riving knife, an improved dust shroud around the blade for better dust collection, a convenient magnetic paddle switch for safe operation, an innovative single - belt design for easier tensioning and less vibration, a motor reset switch relocated to the power switch, a low - profile riving knife, a redesigned guard for enhanced protection and usability, on - board storage for accessories, and CSA certification.
Specifications: Recommended circuit size is 20 amps, motor voltage is 115V, table height from the floor is 34 - 3/4 inches, maximum depth of cut at 45 degrees is 2 - 1/8 inches, motor power is 1 - 3/4 HP, maximum width of dado is 13/16 inches, table size is 20 x 27 inches (44 x 27 inches with extension), motor amps are 14.8, motor phase is 1, arbor speed is 4000 RPM, maximum rip left of blade is 13 - 1/2 inches, maximum depth of cut is 3 - 1/8 inches, miter gauge type is T - Slot with stops, table type is cast iron, arbor diameter is 5/8 inches, minimum dust collection CFM required is 350, maximum rip right of blade is 30 inches, prewired voltage is 115V, maximum diameter of dado is 8 inches, blade diameter is 10 inches, and dust port outside diameter is 4 inches.
Using your Jet ProShop Table Saw is easy. First, make sure you're using the right blade for the job. You can change the blade quickly with the newly designed arbor lock. Before starting, check the quick - release riving knife to ensure it's in the correct position to prevent kickback. The magnetic paddle switch makes it safe to start and stop the saw.
When making cuts, use the exclusive ProShop fence system to guide your material. You can choose between 30' or 52' rip capacities depending on your needs. For non - through cuts and dado cuts, use the included low - profile riving knife and dado insert.
Keep in mind that the saw requires a 20 - amp circuit and runs on 115V. Also, connect a dust collection system with at least 350 CFM to keep your workspace clean.
For maintenance, regularly check the belt tension. The single - belt design makes this easy. Keep the blade sharp and clean, and check the dust shroud around the blade to ensure proper dust collection. If the motor trips, you can easily reset it using the switch on the power switch, not on the motor. And always store your accessories in the on - board storage to keep them organized and within reach.
