This Klein 16477 Wide Range Parallel Jaw Distribution Grip is a must - have for wire pulling tasks. It comes with one wide - range distribution grip. This grip can pull cables from No. 6 Copper to No. 477 ACSR, with a cable diameter ranging from 0.162 to 0.883 inches (4.11 to 22.42 mm). It's 20% lighter than Klein's Cat. No. KT4500 grip, which makes it easier to handle. The one - handed design allows for simple and effortless actuation. A spring closes the grip on the cable to hold the initial position securely. Made in the USA, it features a large opening in the handle that can fit a wide variety of hooks on hoists, winches, and tackle blocks. With a maximum safe load of 5000 pounds (2268 kg), it's reliable and safe for your cable - pulling needs. It's made of steel, has a round jaw type, and is suitable for bare copper, aluminum, and ACSR cables. Its overall length is 10 inches (25 cm), width is 6.5 inches (16.5 cm), and height is 1.25 inches (3.2 cm). The jaw length is 3.31 inches (8.4 cm). It has no swing latch, hot latch, or locking handle, but its one - handed grip is a special feature that stands out.
Using the Klein 16477 Wide Range Parallel Jaw Distribution Grip is easy. First, make sure the cable diameter is between 0.162 to 0.883 inches (4.11 to 22.42 mm). With one hand, open the grip and place the cable inside. The spring will close the grip and hold the cable in place. Then, connect the grip to your hoist, winch, or tackle block using the large opening in the handle. Remember, the maximum safe load is 5000 pounds (2268 kg), so don't exceed this limit. When not in use, store it in a dry place to prevent rust. Clean it regularly with a dry cloth. If you notice any damage, don't use it and contact a professional for repair or replacement.
