Using your Jet JT9 - 725000K Table Saw is straightforward. First, make sure it's connected to a 20 - amp circuit with 115V power as recommended. Before starting, check the blade and all accessories are properly installed. You can use the magnetic paddle switch to turn the saw on and off safely. When cutting, adjust the fence system according to your rip capacity needs, either 30 - inch or 52 - inch. For non - through cuts and dado cuts, use the included low - profile riving knife and dado insert. Remember to always wear safety goggles and other appropriate safety gear. When it comes to maintenance, regularly clean the dust from the blade and the dust shroud around it. You can use a vacuum cleaner with a 350 CFM capacity connected to the 4 - inch dust port. Check the belt tension periodically and adjust it if necessary. If you need to change the blade, use the newly designed arbor lock for quick and easy blade replacement. Keep all the accessories in the on - board storage when not in use. And since it's CSA certified, you can be confident in its quality, but still follow these steps for safe and long - lasting use.
