This Klein conduit bender comes with a complete set that includes a 51427 aluminum head, a handle, and a 51612 Angle Setter™. The 3/4 - inch assembled aluminum bender features Klein's exclusive Angle Setter™ technology, which is patent - pending. It allows for time - saving, accurate, and repeated bends at 10, 22.5, 30, and 45 degrees, adjusted for conduit spring back. The aluminum head is easy to handle and reinforced for greater strength. Bold cast markings and symbols make conduit alignment a breeze for all types of bends, such as saddle and back - to - back bends. The wide foot pedal offers great stability, leverage, and comfort. The interior hook surface stops the conduit from rolling or twisting during bends. Markings for 10, 22.5, 30, 45, 60 degrees and their corresponding offset multipliers are included. It's compatible with Klein's 3/4 - inch Angle Setter™ (Cat. No. 51612) for quick, accurate, and consistent bends. Designed to bend 3/4 - inch EMT, 1/2 - inch Rigid, and 1/2 - inch IMC conduit. Klein Tools' conduit benders with this patent - pending technology enable fast and accurate repeated bends. The foot pedal has angled grooves for extra grip, and visible bold cast - in symbols, degree scales, and multiplier scales save time on the job.
Using this Klein conduit bender is easy. First, make sure you've attached the handle and the Angle Setter™ properly. Place the conduit in the bender, aligning it with the bold cast markings according to the bend angle you need. Use your foot on the wide pedal to apply pressure and make the bend. The Angle Setter™ will help you get an accurate angle. Remember, this bender is designed for 3/4 - inch EMT, 1/2 - inch Rigid, and 1/2 - inch IMC conduit, so don't try to bend other sizes. After each use, clean the bender to remove any debris or dirt. Store it in a dry place to prevent rusting. Check the Angle Setter™ regularly for any signs of wear and tear. If you notice any issues, contact Klein Tools for assistance.
