Greenlee 158DSTRT Back to Back Strut Die Set 1-5/8 x 3-1/4 for 30T Shear

Using the Greenlee 158DSTRT is quite straightforward. First, make sure your Greenlee 30T Shear is in good working condition. Then, use the Quick Die Change System to insert the back - to - back dies into the shear. The die grooves will help you place them correctly. When you're ready to cut, simply operate the shear as you normally would. The high - strength steel dies will give you burr - free and accurate cuts on back - to - back strut made of up to 12 - gauge steel. After each cut, the retaining spring pin hole in the dies will allow them to retract, so you can use them again easily. As for maintenance, keep the dies clean. After use, wipe them down to remove any debris. Also, check the laser - marked catalog numbers and sizes regularly to make sure they're still clear for quick identification. When not in use, store the dies in a dry place to prevent rusting. And always follow the safety instructions of the Greenlee 30T Shear when using these dies.