Using your Jet 714400K Bandsaw is a breeze. First, make sure it's properly set up on the included steel stand. Check that all the parts are in place, like the table insert and the resaw fence. Before you start, plug it into a 20 - amp circuit as recommended. You can use the 115V AC outlet for any optional accessories. When cutting, place your workpiece on the large cast - iron table. The resaw capacity is great for big pieces of wood, but always make sure your hands are a safe distance from the blade. Adjust the upper and lower ball - bearing blade guides according to your needs. You can use the miter gauge for accurate angled cuts. The table can tilt 45 degrees to the right for special cuts. After use, turn off the power and clean up the saw. Use the dual 4 - inch dust ports to connect a dust collection system. It helps keep the work area clean and extends the life of the saw. Regularly check the blade tension and alignment. Lubricate moving parts as needed, and store the saw in a dry place when not in use. Refer to the operating instructions and parts manual for more detailed guidance and maintenance schedules.
