iTOOLco CP02 Center Point Knockout Layout Tool, 5 Pack

Using the iTOOLco CP02 Center Point Knockout Layout Tool is a breeze. First, set it up according to the required 1 - 1/8' or 7/8' gap between conduits on your layout for rigid, IMC, or EMT knockouts. Then, follow the three easy steps to quickly mark the center points, which is 70 times faster than using a tape measure. You can use it in pre - fab work, at job sites, or in panel shops. When pulling branch circuits, refer to the panel schedule on the tool. Keep it in a dry place and clean it regularly to maintain its performance. Avoid dropping it or subjecting it to heavy impacts to prevent damage.