The Milwaukee M18™ FORCE LOGIC™ Long Throw Press Tool Kit stands out as a top - notch solution in the market. This press tool is not only the smallest but also the smartest extended - length press tool available. With an adjustable stroke length, it provides an optimized cycle time for 1 1/2” – 2” Grinnell® stainless steel press connections. Its in - line design is incredibly lightweight, offering unparalleled access around installed pipes while ensuring the highest level of press accuracy and reliability. Using REDLINK™ Intelligence, it comes with auto - cycle and a pre - press battery check. This helps prevent partial presses, giving users complete peace of mind. The green LED indicator clearly shows when a press cycle is complete and when calibration is required. It boasts the longest calibration interval in the industry, running 50,000 cycles before calibration, maximizing your return on investment. Powered by the M18™ REDLITHIUM™ Battery Pack, it's the only press system allowing you to cut, fasten, and connect all in one. The kit includes one M18 FORCE LOGIC Long Throw Press Tool, two M18™ REDLITHIUM™ XC Extended Capacity Batteries (48 - 11 - 1828), one M18 and M12 Multi - Voltage Charger (48 - 59 - 1812), and a hard - carrying case. Its features are outstanding, like a brushless motor for longer life, auto - cycle for full presses every time, and a pre - press battery check. It has an approximate cycle time of 4 seconds (8 seconds for extended stroke) and comes with a 5 - year warranty and a 2 - year jaw warranty. The tool's dimensions are 18.3' in length, 4.7' in height, and 3.4' in width.
Using the Milwaukee M18 FORCE LOGIC Long Throw Press Tool Kit is quite straightforward. First, make sure the M18 REDLITHIUM battery is fully charged. Then, attach the appropriate press jaws for your 1 1/2” – 2” Grinnell® stainless steel press connections. Place the tool around the pipe connection and start the auto - cycle function. The green LED will show when the press cycle is complete. When using, always check the battery before starting a press to avoid partial presses. Regarding maintenance, the tool has a long calibration interval of 50,000 cycles. But it's a good idea to regularly check the tool for any signs of wear and tear. Keep the tool clean and store it in the hard - carrying case when not in use. The charger should be used in a dry and well - ventilated area. If you notice any issues with the tool, refer to the 5 - year warranty for the tool and 2 - year jaw warranty for support.
