Greenlee 12306 PUNCH,RD 3/4 (POP)

Using the Greenlee 12306 punch is straightforward. First, make sure you have the right draw stud and die that match this punch. Place the material (like mild steel, aluminum, fiberglass, or plastic) where you want to make the hole. Then use the punch along with the draw stud and die to create the 3/4 - inch hole. When using it, always wear safety goggles to protect your eyes from any flying debris. After each use, clean the punch with a dry cloth to remove any dirt or debris. Store it in a dry place to prevent rusting. If you notice any damage or wear on the punch, stop using it and get it checked or replaced.