INCLUDES: One Parallel Jaw Grip suitable for HDPE wire up to 1.362 inches. This grip is a game - changer for pulling HDPE - coated cables, often referred to as 'tree wire'. Its unique high - traction surface firmly holds the cable without harming the outer layer. It can handle cable diameters from 0.625 inches to 1.362 inches (15.875 to 34.595 mm). With a maximum safe load of 4000 pounds (1814 kg), it's reliable for heavy - duty tasks. The tough carbide grit technology makes it durable enough to withstand the toughest jobsite conditions. It's spring - loaded, allowing for one - handed operation and easy placement on the conductor. Common types of tree wire cables it can work with include general cable, Hendrix® aerial systems, rite lite BLL conductor, and Southwire® S2 covered cable. Hendrix® is a registered trademark of Marmon Utility, LLC, and Southwire® is a registered trademark of Southwire Company, LLC. Specifications: It's a Parallel Jaw Grip designed for a wide range of cable pulling. It features a high - traction grip surface. The overall length is 12.5 inches (317.5 mm), height is 8.5 inches (215.9 mm), and width is 2.75 inches (69.9 mm). Made of forged steel, it's suitable for HDPE - coated cables. The cable diameter it can handle ranges from 0.625 inches to 1.362 inches (15.9 to 34.6 mm). The jaw length is 4.5 inches (114.3 mm) with a round jaw type. The maximum safe load is 4000 lb (1814 kg), and it meets OSHA standards. It weighs 5.10 lb (2.31 kg). This grip is specifically engineered to securely pull slippery HDPE - coated cables or tree wires, with its high - traction surface and tough technology.
Using the Klein 1716 - 70 Parallel Jaw Grip is easy. First, make sure the cable diameter is between 0.625 inches and 1.362 inches. Since it's spring - loaded, you can use one hand to open the grip and place it on the conductor. Once it's on the cable, you're ready to start pulling the HDPE - coated cable or tree wire. Just remember, don't exceed the maximum safe load of 4000 pounds. This is important for your safety and to avoid damaging the grip. When you're done using it, clean it to remove any dirt or debris from the jobsite. You can use a dry cloth to wipe it down. Store it in a dry place to prevent rusting. Regularly check the carbide grit surface for wear and tear. If it seems too worn, it might be time to get a new grip. Also, always follow OSHA standards when using this tool on the jobsite.
