Using your Jet JT9 - 414453 J - 3230 Horizontal Bandsaw is straightforward. First, make sure it's properly plugged into a 115V, 1 - phase power source. Adjust the blade guides according to the material you're cutting. You can set the blade speed to 85, 125, or 200 SFPM based on your needs. Use the adjustable material stop to get accurate cuts. When you're ready, start the machine and use the hydraulic downfeed system to lower the blade onto the material. The saw will automatically shut off after the cut is complete. For maintenance, keep the oil bath for the worm gear and worm drive filled. Check the coolant system regularly and refill it as needed. Make sure to clean the saw after each use to prevent debris buildup. Also, always follow the safety guidelines set by the CSA Group to avoid any accidents.
